Blog Home :: Rayfields Decorating Home :: Contact Information

DIY By Design : Blog of Rayfields Decorating

How to fit a sliding door bolt :: Posted by: Admin on December 2nd, 2012

How to fit a sliding bolt lock

Sliding door bolt locks also known as barrel bolts are a simple way to add a lock to a door, they come in different sizes depending on how big your door is or how strong you want them to be. The all come in different styles such as straight, necked or flat sliding bolts. They are easy to fit. You can also fit padlock bolts that you would typically see on gates and sheds in the same way.

Tools required to fit a sliding bolt

You will need the following tools to fit your bolt:
sliding bolt

  • A sliding bolt set consisting of a sliding bolt and a staple
  • Fixing screws – These normally come with the lock set
  • A Pencil
  • A carpenters try square
  • A Drill
  • A Drill bit to dill pilot holes
  • A Screwdriver or bit for your Drill
  • A chisel
  • A Hammer

Once you have gathered all the tools you require you can start to fit your bolt.

Fitting the bolt

The first job is to decide on the height and placement of your bolt, this could be at the top or bottom of your door for security reasons or in the middle of the door at hand height if it to keep people out such as in a toilet or bathroom.

Once you have decided on the height of the bolt, draw a straight line on the door using a square and pencil.

Now align the edge of the body of the bolt on the line on the door and mark the holes for fixing, making sure the bolt body doesn’t stick out past the door and is flush with the door edge.

Next take your drill and drill bit, making sure the drill bit is slightly smaller than the thickness of the screws you are going to use. Drill small pilot holes in the door to aid screwing in the crews, don’t make the holes too deep, just enough to get the screw started.

You can now screw the bolt body onto the door, at this stage take the staple, which is the part the bolt goes into and the part that is screwed to the door frame, offer the staple up on the door frame, does the frame and architrave need chiselling out?
If you do need to remove some architrave and or frame draw around the staple and chisel out the required amount of wood. If you don’t have to remove any architrave or frame try holding the bolt on the frame and sliding the bolt over, does the bolt go in the staple easily? In some cases you may have to pack the staple with cardboard behind it to allow the bolt to slide into the staple easily. This will depend on if your door is warped or how flush the door has been hung.

Once you have done this you can mark the holes on the door frame for the staple, then drill pilot holes and screw on the staple.

Try the bolt for ease of use, your sliding bolt is now fitted.

Top Tiip

Top Tip: A really good tip to fit the staple to the frame, once the bolt body is fixed to the door hold the staple on the frame, slide the bolt into the staple, leave the bolt in the staple whilst you drill the holes for the staple and screw it to the door frame, this will keep it in-line with the bolt and the bolt will work freely and easily.

Tags: , , , , , , ,
Posted in DIY Tips, Video | No Comments »


DIY By Design

DIY Blog : Trade Tips For the Do It Yourself Enthusiast